Pattern Revisions for Debbie Bliss Magazine Fall/Winter 2008
2. A Line Cabled Top
Please note the width shown on the schematic, refers to the width of the piece just below the armhole shaping, not the width of the lower edge.
With right side facing and 4.50mm (US 7) circular needle, rib across 61(61:69:69) sts of Left Sleeve, rib across 104(112:120:128) sts of Front, rib across 60(60:68:68) sts of Right Sleeve, then rib across 105(113:121:129) sts of Back.
Next row (wrong side) K2, [p2, k2] to end.
Next row (right side) [P2, k1, ssk, rib 52(52:60:60), k2tog, k1, p2, k1, ssk, rib 96(104:112:120), k2tog, k1] twice, p2.
Next row [K2, p1, p2tog, rib 94(102:110:118), p2tog tbl, p1, k2, p1, p2tog, rib 50(50:58:58), p2tog tbl, p1] twice, k2.
Next row [P2, k1, ssk, rib 48(48:56:56), k2tog, k1, p2, k1, ssk, rib 92(100:108:116), k2tog, k1] twice, p2.
Next row [K2, p1, p2tog, rib 90(98:106:114), p2tog tbl, p1, k2, p1, p2tog, rib 46(46:54:54), p2tog tbl, p1] twice, k2.
Cont in this way to dec 8 sts on next 9 rows, so ending with a right side row. 226(252:274:290) sts.
4. Cabled Beret
Row 35 P2, [k4, C8F, p2] to end.
7. Drop Collar Cabled Jacket
Moss st row 1 [K1, p1] to end.
Moss st row 2 [K1, p1] to end.
Moss st row 3 [P1, k1] to end.
Moss st row 4 [P1, k1] to end.
The measurements for the Right Front before working the armhole, should read: 32(32:33:33:34:34)cm/12½(12½:13:13:13½:13½)in
8. Cabled V Neck Slipover
C10F = slip next 5 sts onto cn and hold in front of work, k5, then k5 from cn.
Please work C10F instead of C10B throughout (Front - Rows 3 and 13 all sizes).
20. Cable Vent Jacket
After Dec row 4...
Cont in patt with 5 sts in rev St st between panels, work 7 rows.
Dec row after Shape armholes, should read: K2, k2tog, patt to last 4 sts, skpo, k2.
25. Egg Cozies
26 sts and 35 rows to 10cm/4in over St st using 3.5mm (US 4) needles.
36. Cable and Diamond Lace Socks
Round 9 of the pattern after the rib should read:
Rnd 9 * P2, k6, p2, k1, [k2tog, yo] twice, k2; rep from * 4 more times.
Row 2 Sl 1, yb, p20, yf, sl 1, yb, turn and leave 2 sts.
You will find the decrease round needed before shaping the toe, has been misplaced and can be found further down the same column, just before the last round.